I have a Carver Caravelle Trumatic SBE 1800 in my old swift danette (1981) & non of the wires are connected (all unplugged or snapped)
Red, Blue, Black, Green, White, Yellow, from Temp controller.
Live & Earth both In-line Fused from fuse box
Brown & Blue From Gas regulator the Brown wire has what looks like a rivet through it with a few spade connectors snapped on it with a thick grayish wire still attached with a large spade connector on the end.
Igniter has a wire copper wire connected with a heat shield on it going down into the fire unit.
Also a wire coming out of the fire unit with a heat shield on whitish wire with a blue covered small spade connector plugged into a connector block?
No it controls the room temperature, the water heaters sensor being on the other end of the unused white wire, yours is in on control switch.
Carefully check the solder tags of the component the dials connected too, ones not connected to anything but the other two are and are often cracked.
Also the similar but smaller component on one end of the board, this is fine adjustment and the centre slot is marked with an arrow at one end, make sure this arrow points up between twelve and one O'clock.
Also make sure you have a 'caravelle' switch, the water heater switch will work but obviously in a different far higher temperature range
Thanks again gary mate il have a look at it tonight when i finish work.
I dont have a water heater but was unsure about the dial as i have never used the fire before.
Thanks
Steve.
Hiya sorry to hijack a old thread , can you tell me what pins arr what coulour on tge heater end ( phone conector starting at the latch side ) also is the power piggy backed in to the heater as there is no seprate wire , do you still conect the white wire , arc have emaild you pictures via ur web site
Amazing family weekend with old steam engines, classic car displays, market stalls, and full catering and bar. And camping on site - Save £25 by booking in advance.
Topic: Carver Caravelle Trumatic SBE 1800 Wiring
