Hi
On the outlet side of the pump piping, you will find a brass / copper connector (i think) inside that is wire mesh.
Clean that and you should be fine.
Had that problema a few years ago on our indiana s6.
And that sorted the problem out.
not sure. dont think it did.
Its the right hand blue vavle that you need to strip.
you turn the valve in a diffrent direction for on board tank and direct water. been a while since i have done it and can't remember of top of my head.
I stripped pump down and it still did same, and not knowing anything differant bought a new pump.
And no improvement.
So stripped it down and found the mesh. Costly mistake, but on the bright side have a spare pump lol, and still fits the barcelona as well.
Hi back again
Been away in the van and still having problems even after stripping and cleaning the motor
I connected the aquaroll as normal and set to aquaroll to taps but no water appeared
The I set to fill onboard tank from aquaroll and still didn't work, so I pulled the pipe out of the onboard tank filler pipe and sucked on it until the water came through then it will fill tank , if I then switch to van taps it works fine
but if I leave it a few hours it fails again until I suck out the air again
I can see no leaks inside van but if I remove the aquaroll pump whale it drips water which I am sure this didn't happen before
So I'm guessing there is s nonnreturn valve somewhere that is leaking?????
Any ideas
------------- Advice is what we ask for when we already know the answer but wish we didn't.
Amazing family weekend with old steam engines, classic car displays, market stalls, and full catering and bar. And camping on site - Save £25 by booking in advance.